de
page
SP-41
External speaker featuring 4 audio filters, 5 W power output and 8 Ohms impedance, equipped with two tone selection switches (High: Cut/Wide and Low: Cut1/Cut2). The front panel includes an A/B audio input selector, a speaker On/Off switch, and a 6.35 mm (1/4") headphone jack. The rear panel is equipped with two 3.5 mm audio input jacks. Supplied with two 3.5 mm to 3.5 mm audio cables. Dimensions (W × H × D): 145 × 118 × 277 mm.
-
Cliquez pour agrandir
-
Cliquez pour agrandir
Les + Produits
- Rated Input Power: 5 W - Maximum Input Power: 7 W
- Two tone selection switches (High: Cut/Wide and Low: Cut1/Cut2)
- Front panel: A/B audio input selector, speaker On/Off switch, 6.35 mm headphone jack
- Rear panel: two 3.5 mm audio input jacks
- Dimensions (W × H × D)(projections not included): 145×118×277mm
- Supplied with two 3.5 mm to 3.5 mm audio cables (length: 1.5 m)
Others
RC-7760
Optional additional controller for IC-7760. Up to five controllers may be connected to the single RF deck via the IP netword (L2 VPN necessary to accommodate multiple controllers at the same location). Only one controller works at the same time. Use under a higher latency network with the new IC-7760 firmware (same level as the RS-BA1: up to 400mS latency): LAN networks over the Internet, Wi-fi connected networks, VPN networks. Supplied with AC Adapter 15V 3A, 1800mm cable length. Hand microphone not supplied.
Fixed stations
IC-7300MK2
Ham transceiver HF/50 MHz 100W, 70 MHz 50W, 1,8-30MHz, 50-52MHz, updated version of IC-7300 with RMDR/phase noise characteristics improved, lower heat generation, reduced curr. consumption, CW decoder function, new connections: HDMI, USB-C, Ethernet and RX antenna port. 100 channels, touch screen LCD TFT display, keypad, all modes, integrated antenna tunner, control, IF output, voice recording with SC card. Any modification to the equipment not carried out by the ICOM France after-sales service will result in exclusion from the manufacturer's warranty.
IC-7610
Ham transceiver HF/50MHZ, 100 W, 99 channels, all modes, with 7 inch touch-screen TFT LCD with spectrum scope, dual watch function, FPGA based RF direct sampling, USB ports, Ethernet port, SD card slot for voice recording, screen capture, log file. Supplied with hand microphone and power supply cable. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.
IC-7760
Ham base radio, HF/50MHz, 1.8-30/50MHz and 5MhZ, 200W, dual independent receivers, dual watch, two colour screens, separated RF main united from the IP controller connected by the gigabit Ethernet cable, DPD (digital pre-distortion) capability, simultaneous use of digital preselector and preamplifier, direct sampling / FGPA technologies. Supplied with control cable, AC adapter and power cable, desktop stand. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.
IC-9700
Ham digital transceiver VHF/UHF/1200MHz, tri-band transceiver (144-146MHz, 430-440MHz,1240-1300MHz), output power 100/75/10W, 2420 channels, all modes (SSB, CW, RTTY, AM/FM, DV, DD) with 4,3" touch screen color TFT LCD and keypad, spectrum scope, dualwatch operation and full-duplex operation in the satellite mode, LAN port, USB/B port, D-STAR compatible (digital clear audio and Internet capable communication), voice recording / playback function (via SD memory card). Supplied with hand microphone and DC power cable. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.
