de
page
RC-7760
Optional additional remote control head for the ICOM IC-7760 HF/50 MHz transceiver, identical to the controller supplied with the radio. Remote operation without a PC via an IP network, including over the Internet. Two colour touchscreens, 7 inches and 2.4 inches, for intuitive operation. Control of both receivers and spectrum scopes. Two built-in speakers for high-quality audio. Connection of up to 5 controllers to a single RF unit, with only one active at a time. Support for network latency of up to 400 ms, thanks to updated IC-7760 firmware. Flexible connectivity via Ethernet, Wi-Fi (using a LAN-to-Wi-Fi converter) or VPN. Ideal for contesting, DXing, multi-position stations and remote QTH operation. Please note: Wi-Fi connectivity requires an external LAN-to-Wi-Fi converter. Internet operation may require specific network configuration (port forwarding or VPN).
-
Cliquez pour agrandir
Les + Produits
- Remote operation without a PC, via IP network, including over the Internet
- Two colour touchscreens, 7 inches and 2.4 inches
- Connection of up to 5 controllers to a single RF unit, with only one active at a time
- Support for network latency of up to 400 ms, thanks to updated IC-7760 firmware
- Flexible connectivity via Ethernet, Wi-Fi (using a LAN-to-Wi-Fi converter) or VPN
- Ideal for contesting, DXing, multi-position stations and remote QTH operation
Microphones
SM-50
Unidirectional dynamic table microphone with 8-pin connector, PTT key with lock, switches [UP/DOWN] and low cut function [Low/Cut]. Output impedance: 55 Ohms ±30% (at 1 kHz). Microphone gain: -30 dB ±4 dB. Cable length (approx.): 1m. Requires an 8-pin mic plug adapter for workstations equipped with an RJ45 mic plug.
Softwares
RS-BA1 V2
IP remote control software (V2 version) to manage ICOM radios from a PC. Dualwatch operation with dual spectrum scopes. Covers most functions and modes. Low latency, high quality audio over an IP network. Optional USB remote encoder RC-28. Delivered on a CD or USB key depending on the version.;
Speakers
SP-41
External speaker featuring 4 audio filters, 5 W power output and 8 Ohms impedance, equipped with two tone selection switches (High: Cut/Wide and Low: Cut1/Cut2). The front panel includes an A/B audio input selector, a speaker On/Off switch, and a 6.35 mm (1/4") headphone jack. The rear panel is equipped with two 3.5 mm audio input jacks. Supplied with two 3.5 mm to 3.5 mm audio cables. Dimensions (W × H × D): 145 × 118 × 277 mm.
Fixed stations
IC-7760
Ham base radio, HF/50MHz, 1.8-30/50MHz and 5MhZ, 200W, dual independent receivers, dual watch, two colour screens, separated RF main united from the IP controller connected by the gigabit Ethernet cable, DPD (digital pre-distortion) capability, simultaneous use of digital preselector and preamplifier, direct sampling / FGPA technologies. Supplied with control cable, AC adapter and power cable, desktop stand. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.