HM-219

OPC-589

8-pin connector microphone to 8-pin modular, 30 cm cable length.

RC-7760

Optional additional remote control head for the ICOM IC-7760 HF/50 MHz transceiver, identical to the controller supplied with the radio. Remote operation without a PC via an IP network, including over the Internet. Two colour touchscreens, 7 inches and 2.4 inches, for intuitive operation. Control of both receivers and spectrum scopes. Two built-in speakers for high-quality audio. Connection of up to 5 controllers to a single RF unit, with only one active at a time. Support for network latency of up to 400 ms, thanks to updated IC-7760 firmware. Flexible connectivity via Ethernet, Wi-Fi (using a LAN-to-Wi-Fi converter) or VPN. Ideal for contesting, DXing, multi-position stations and remote QTH operation. Please note: Wi-Fi connectivity requires an external LAN-to-Wi-Fi converter. Internet operation may require specific network configuration (port forwarding or VPN).

IC-7100

Ham mobile radio HF/50MHz/VHF/UHF, 100/70/50/35W, 505 channels, multiple modes, touchscreen, 3.6 inch FSTN display, D-STAR DV compatible mode, SD memory card slot for saving data

IC-718

Ham radio HF all bands transceiver 0.5-30 MHz, 100W, 101 memory channels, LCD display and keyboard, front panel with standard IP-X4, USB LSB CW RTTY (FSK) AM modes, MIL-STD 810G compliant. Supplied with hand microphone, DC power cable and spare fuses

IC-7300MK2

Ham transceiver HF/50 MHz 100W, 70 MHz 50W, 1,8-30MHz, 50-52MHz, updated version of IC-7300 with RMDR/phase noise characteristics improved, lower heat generation, reduced curr. consumption, CW decoder function, new connections: HDMI, USB-C, Ethernet and RX antenna port. 100 channels, touch screen LCD TFT display, keypad, all modes, integrated antenna tunner, control, IF output, voice recording with SC card. Any modification to the equipment not carried out by the ICOM France after-sales service will result in exclusion from the manufacturer's warranty.

IC-7610

Ham transceiver HF/50MHZ, 100 W, 99 channels, all modes, with 7 inch touch-screen TFT LCD with spectrum scope, dual watch function, FPGA based RF direct sampling, USB ports, Ethernet port, SD card slot for voice recording, screen capture, log file. Supplied with hand microphone and power supply cable. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.

IC-7760

Ham base radio, HF/50MHz, 1.8-30/50MHz and 5MhZ, 200W, dual independent receivers, dual watch, two colour screens, separated RF main united from the IP controller connected by the gigabit Ethernet cable, DPD (digital pre-distortion) capability, simultaneous use of digital preselector and preamplifier, direct sampling / FGPA technologies. Supplied with control cable, AC adapter and power cable, desktop stand. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.

IC-9700

Ham digital transceiver VHF/UHF/1200MHz, tri-band transceiver (144-146MHz, 430-440MHz,1240-1300MHz), output power 100/75/10W, 2420 channels, all modes (SSB, CW, RTTY, AM/FM, DV, DD) with 4,3" touch screen color TFT LCD and keypad, spectrum scope, dualwatch operation and full-duplex operation in the satellite mode, LAN port, USB/B port, D-STAR compatible (digital clear audio and Internet capable communication), voice recording / playback function (via SD memory card). Supplied with hand microphone and DC power cable. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.