de
page
SM-50
Unidirectional dynamic table microphone with 8-pin connector, PTT key with lock, switches [UP/DOWN] and low cut function [Low/Cut]. Output impedance: 55 Ohms ±30% (at 1 kHz). Microphone gain: -30 dB ±4 dB. Cable length (approx.): 1m. Requires an 8-pin mic plug adapter for workstations equipped with an RJ45 mic plug.
-
Cliquez pour agrandir
Les + Produits
- One-way dynamic microphone with integrated preamp
- Flexible gooseneck for precise positioning
- PTT key with lock function
- Low-cut filter to reduce handling noise and low frequencies
- Adjustable microphone output level
- Compatible with a majority of ICOM transceivers (use the OPC-589 adapter sold separately)
Others
RC-7760
Optional additional controller for IC-7760. Up to five controllers may be connected to the single RF deck via the IP netword (L2 VPN necessary to accommodate multiple controllers at the same location). Only one controller works at the same time. Use under a higher latency network with the new IC-7760 firmware (same level as the RS-BA1: up to 400mS latency): LAN networks over the Internet, Wi-fi connected networks, VPN networks. Supplied with AC Adapter 15V 3A, 1800mm cable length. Hand microphone not supplied.
Fixed stations
IC-7300MK2
Ham transceiver HF/50 MHz 100W, 70 MHz 50W, 1,8-30MHz, 50-52MHz, updated version of IC-7300 with RMDR/phase noise characteristics improved, lower heat generation, reduced curr. consumption, CW decoder function, new connections: HDMI, USB-C, Ethernet and RX antenna port. 100 channels, touch screen LCD TFT display, keypad, all modes, integrated antenna tunner, control, IF output, voice recording with SC card. Any modification to the equipment not carried out by the ICOM France after-sales service will result in exclusion from the manufacturer's warranty.
IC-7610
Ham transceiver HF/50MHZ, 100 W, 99 channels, all modes, with 7 inch touch-screen TFT LCD with spectrum scope, dual watch function, FPGA based RF direct sampling, USB ports, Ethernet port, SD card slot for voice recording, screen capture, log file. Supplied with hand microphone and power supply cable. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.
IC-7760
Ham base radio, HF/50MHz, 1.8-30/50MHz and 5MhZ, 200W, dual independent receivers, dual watch, two colour screens, separated RF main united from the IP controller connected by the gigabit Ethernet cable, DPD (digital pre-distortion) capability, simultaneous use of digital preselector and preamplifier, direct sampling / FGPA technologies. Supplied with control cable, AC adapter and power cable, desktop stand. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.
IC-9700
Ham digital transceiver VHF/UHF/1200MHz, tri-band transceiver (144-146MHz, 430-440MHz,1240-1300MHz), output power 100/75/10W, 2420 channels, all modes (SSB, CW, RTTY, AM/FM, DV, DD) with 4,3" touch screen color TFT LCD and keypad, spectrum scope, dualwatch operation and full-duplex operation in the satellite mode, LAN port, USB/B port, D-STAR compatible (digital clear audio and Internet capable communication), voice recording / playback function (via SD memory card). Supplied with hand microphone and DC power cable. Any modification to the equipment not carried out by the ICOM France service department of ICOM France will invalidate the manufacturer's warranty.